Search results for query: *

use less mountain dew in the mixture

them will clean up nice, I lost your phone number

71 has recessed marker light 72 is flat I have a driver side fender for 72

alchohol abuse is punishable......just don't even go there, Jes Sayin

chrome rustoleum over a prepped sanded primer does a nice job, that tin foil looks like (fill in the blank)

I'm with this or continue the graphix

put the paint on wet and evenly then bake in the sun or oven to get even wrinkles I use vht and it works well

I would hang,adjust and alighn all the front sheetmetalto where it fit perfectly then see what can be done to make the rear sheet metal come out as nice as you did on the front sheetmetal...nobody says you cant do it better than the factory yo might check fit the 1/4's during this process using...

you can use a dark color of basecoat thinned out and misted on for a guide coat that will save a few bucks

a guy was trying to buy my original for pennies used their reproduction as a tire kicker I mentioned he should run and get him one ;)

In all my years playin with mopar i have never seen one on the drivers side???

you got a paintjob and cut & buffed in the same month??? yur doin good!!!!

you got something bent

Git with challengergary and see what he comes up with, I think tastefully done would be awesome.....Wagg's

great tip Thank's!!!

what year make and model...may have some for ya....

i have only used floor pans, trunk pans , trunk extensions and such and one tailpanel for a 73 duster and everything fit and looked very well and the thickness of the metal seemed very close

One of them green propane tanks from walmart and an afternoon with a scraper and the undercoating is gone...some say molten tar balls in your face I say don't git under them......wear gloves, long sleeve shirt and face protection,costed me 175.00 to do that amount of work after I scraped off the...

I just used dodge dakota wheel lips for my project after the welding and grinding use some duraglass for a thin first coat to help seal her up from moisture

I'd be calling them back a.s.a.p. to come fix it or return the money so you can get a real glass guy out there

grey bondo with blue hardener

when i did dad's fish they dented in the holes and filled with great stuff and then covered with bondo and it musta been in there for at least 10 years and surprisingly still strong,i have bondo in my duster...it needed the 1/4 replaced...I hammer and dollied it then skim coated sanded down and...

no way to be certain unless you try it, seems you may need the duster mechanisims for duster glass and dart mechanisims for dart glass??

yepp.....don't push to hard or the rope will want to cut the gasket...beer is for after the job is done

thin film of sealer , then put the gasket on the glass set the bottom of it into place and feed a 1/4 inch rope in the channel of th gasket, while aplying slight pressure slowly pull the rope moving from one side to the next and it will pull the gasket into the car and Viol'a

If you can pull it off it will be one of a kind, the rewards for a job well done/idea well exacuted will be countless...Mo-power to ya!!!

blair spot weld cutter, I would take the torsion bar x member and all, leave just the k frame still bolted on solidly will keep everything square, and add subframe connectors when you get it done

25$ see if ya need some window parts and they can be shipped in the same package

yes, the bottom of the seat gets pushed at the very bottom of its frame backwards toward the rear of the car then lifts up and comes forward to realease it, the upper part of rear seat has two tabs or two bolts holding it, then after those are released you pull straight upwards to get the seat...

cut thru the a and c pillars, you'll be done in hours rather than decades, make you cuts clean and precise and leave a lil for trimming it down to fit