Search results for query: *

I am ready to start banging my head against the wall. Last year, when I re installed our gas tank, I bought a new seal, cleaned up that section of the tank and re installed a new sender. It leaked when the tank was filled past the sender. So I decided to replace the sender since we were...

Hi, I am buying a new on for the '75 Duster. Apparently, there are 2 listed. One is 5/16” outlet or 3/8” outlet w/a return line. Mine didn't have a return line so would the other be an upgrade ? I have a mopar gas gauge. Thanks Ian,

Not sure what to call this problem. Rebuilt 360, Edelbrock Performance Intake Manifold, Holley 670, new gas pump TTis.. When driving at a constant speed, you can hear the engine going up and down slightly...but not enough to affect the speedo.. but having perfect pitch, this is driving me...

When we pulled all the pollution crap off the car, I just plugged the vent. We has suffered no problems with drivability but reading one thread on his car lunging, it has started to make me think. Should I unblock the tube and stick some sort of filter on it ? Thanks Ian.

Dumb question, I know.. I have a Holley 670. I have installed a lokar kick down cable. The V8 accelerator cable was too long so I put the old one back in. I see a place where I can connect the cable to the carb but shouldn't there be a holder for the cable..not sure if I am saying this...

I know it goes up the passenger's side but how does it snake around the k frame and rear end ? I apologize for this question but we lost all the pics we took when we took the car apart. Thanks Ian.

Folks, Bough a Holley 670 for my 360. Opened up the bran new cd with install instructions, etc and the darn thing is damaged. I looked through the Holley site and didn't see much on this carb. Does anyone have a link for install, etc ? Thanks ian.

H, I hope to be able to start working on the car again. I have been pondering the running of the brake / gas lines and after studying them out of the car, they look like a contortionists worst nightmare. can I run them straight back without all the double bens, etc.. THis is a runner, not a...

We just took our gas tank off and the condition looks awesome but it old. Since most gas tanks rot from the inside out, I want to line it before we put it back on the car. I have the liquid but have been told that I need to remove any gum, sludge, varnish that has accumulated over the years...

..and how to set the float. I shot some carb cleaner into it this afternoon..it starts easily but it still sputters around corners..seems to be more left than right... The PO went a bit nutz with the tar..can you buy wiring harness from the firewall out ? ..or is there an easy way to clean the...

Folks, I am doing as much as I can to get ready to do the install and conversion as problem free as possible ..and on a really tight budget. Anyway, I was looking around for a rebuild kit for my Holley..and as all might know, sometimes it is hard to tell what model it is so I took a bunch of...

I have found a bunch of numbers on this carb but none indicating what model it is. Here are 5 pictures of it. http://yamigrl.smugmug.com/Cars/carb/9393025_nGsWB/1/629137771_moN2B It looks like someone wired shut the choke in picture 2 or diddled it some way. The last owner said that all we...