Search results for query: *

Does anyone know if they are any good? Who makes them? Require custom push rods? Any info would be great! Thanks, Brian

Good Morning, I have been researching a lot lately on heads. Looking at Iron and Alum. Can't find a straight answer on what piston CC works best with Alum. I hear you should calculate 1 compression point higher than Iron, some say it doesn't matter. Anyone have any experience suggestions? If...

Hey Mopar Heads, I am building a stroker 360. Not sure of the bore yet. I bought Scat cast 4" crank, 4340 I-Beams, arp main studs for windage and clevite bearings. How do I know what piston bore size to buy. Do I take my block for boring first then buy them? and also how much does it cost to...

Hey everyone, So I took my block all the way out today and noticed it is missing the rear main cap and two of the middle ones. This block is a 360 and has a 1971 Casting date. I just went to Pick your Part and found a 360 with a 1977 casting date. My question is; Will the Main Caps off the 77...

I found this advertised for $649. I am building a 4.00 stroke 360. I do have 2 360 blocks but unknown if cracked or even good. One is in my Duster now. I figure this could save me some hassle of driving around and taking apart my old blocks. 1. is it worth the price? 2. will arp main studs...

Hey everyone... I got my crank and rods for my 408 bulid.. Scat 9000 4.00 stroke and 4340 I-beams... What bearings do I need. I have been looking at the ACL bearings on CnC's website... They seem like the least expensive or are they CHEAP? Chamfered or non-chamfered... They also say 71-73 360...

Hey everyone, I just picked up a brand new RPM Airgap for my 360 from my buddy for $175... YaY!!!! Yes, it's a true Edelbrock. I am currently running an LD340 on it (cracked my first RPM on install). What will be the difference in performance? any gains?pros and cons? Thanks everyone!!! Hope to...

Hey everyone, I put on a new elec fuel pump due to massive vapor lock problem with my Mech Carter. Now that it is fixed... I need to take the Carter off and put a plate on. I have one but do I need to drain oil or anything other than just removing the pump, cleaning the surface and reinstall the...

Hello everyone, I have made the decision to just go with a performance rebuild of my 360 (factory crank, rods, j-heads, .030 bore, 10:1comp, air Gap ect.) Does anyone know any machine shops that are knowledgeable, Honest and fairly priced where I can get this stuff done (block work, and short...