Search results for query: *

Just a short video I found on YouTube. For informational purposes only. Enjoy.

I’m putting together the W2s for my stroker build and came across a little hiccup. I installed the valves and springs and noticed the installed height varies from intake to exhaust. Approximately.050” difference. Exhaust side is higher. I figure this is due to the 2.08” intake valve being...

Sooooo, this engine has been a very long time coming. I picked up a 340 shortblock about 10 years ago and stashed it in the corner of the garage and proceeded to daydream of building a gnarly-***, tire-frying, rip-roaring beast of a smallblock. It is dated 7/70 so I assume it came in a 71 model...

Mopar Chrysler SB 318 340 360 7.25" SFI Approved Fluid Harmonic Balancer Damper | eBay Anyone here have experience with this balancer? Looks like a Chinese version of the Fluidamper. For half the price of the Fluidamper unit I may give it a try and keep a close eye on things. What balancer is...

Are these correct for a 72 Duster with 318?

Ok, so this little project is on the verge of snowballing into a giant pile of wasted money. All comments and advice are welcome. Here goes, Last weekend I yanked the 318 out of my Duster to replace a leaking rear main seal, replace timing set, and give it a general once over and cleaning. Upon...

Does anyone have experience with this cam in their smallblock? Hydraulic Flat Tappet Camshaft; 1964 - 2003 Chrysler 273, 340, 360 1800 to 5800 Howards Cams 711451-08 | Howards Cams What was the rest of your combo and did you like it? Thank you, drive through.

Hi, thinking about buying the Moroso 8qt. pan 20710 and 24770 pickup for my 340. I'm running a 4" BPE crank and Callies Compstar rods, and Melling m72HV pump. Going into a 72 Duster. Anyone running this pan in their A-body? Just curious about any fitment issues that may arise. Thanks.

Picked up my 340 block from the machine shop few days ago. Was looking it over and noticed a couple things that threw me off. First of all I noticed the word "RACE" stamped on the front wall, behind where the cam gear would be. Second, there are no numbers stamped on the ID pad on the pan...

I'm in the market for a stroker kit for my 340. Who makes a good all inclusive kit that is ready to drop in? I have a good set of worked W2s for it and it's going into a 72 Duster that will see mostly street duty and showing off at cruise-ins with the occasional pass on the 1/4. Hughes...

I'm ready to begin my stroker build and was looking for a little advice/tricks from some of you guys that have built them. Here's what I'm working with: '70 340 block bored .060 over 4" forged eagle crank eagle SIR rods flat top pistons W2 race heads with mild porting and 2.09/1.60 valves...

I have a set of w2 econo heads but I don't know if they take the long valves or the regular length valves. How do you tell? The casting number is 3870810E and they have the rocker stands cast on the head. Also, if they are long valve, who makes valves in this size? I am assuming that the long...

Who makes a good set of rockers for the W2 Econo head? I know Harland Sharp makes them but they have a big price tag. I think Mopar might still make them but not sure and also Crane but they don't come with the rocker shaft. Can I use a stock rocker shaft on the Econo head? Anyone know of...