Search results for query: *

anyone used a mr gasket regulator? this is all the local parts house carries. are they accurate or should i go with a better brand? thanks

i have a stock 273 cast iron intake on a 318 with 600 eddy performer carb. runs great but is boiling fuel to the point it doesnt want to idle. does anyone have a part number for a phenolic spacer and a thickness recomendation to help with this? currently has an open 1inch aluminum...

i have a 73 valiant 318 with small cam and edelbrock 600 performer carb. i got the calibration kit and leaned the cruise stage out 2 stages. runs great but idle isnt steady. bought a vacuum guage and when i hooked it up to start with i had about 15inches at idle but very erratic reading...

my 600 eddy performer just isnt much of a performer. thinking of a totally different brand. would like to try holley or possibly the summit street strip. this is my cam specs. everything else pretty much stock fresh valve job and a factory 4bbl intake Advertised Duration (Int/Exh): 284/284...

put a used 600 performer on a mildy cammed 318. occasionally gas will come out of the tube beside the hole for the metering rods on the left side top of carb. would this be caused by the float level. carb is clean inside have not checked the float. it also surges at low speeds and sometimes acts...

the fuel pump in my 73 valiant 318 has quit on me for the second time. i put a new one on from advance less than a year ago it quit 2 months ago. got another one under warranty and it quit last night in the middle of a cruise in. should i be getting a different pump maybe going to electric? also...

i tried a used 273 intake and if you saw my last thread it was a big prob maybe not related to intake but to be sure i want to buy a new alluminum intake. the engine is a 73 318 stock comp ratio reserfaced heads with full valve job lunati cam Duration @ .050 (Int/Exh): 218/218 Gross Valve Lift...

i recently picked up a 4bbl carb and intake swaped it out had problem with the intake and ended up going back with the 2bbl due to lack of funds. my carb is junk and i have a good 600 edelbrock performer. my question is if i buy and adapter to put the 4bbl on the 2bbl intake will it work untill...