Thanks
I took everything apart and off to the plater.
Bar Plating in Meriden CT did the chrome plating except for the plastic. Plastic chroming in Miami did it, since he has moved to Texas
Last edited:
68 Barracuda 225 to 440 to 426
- Thread starter davescuda
- Start date
-
I took everything apart and off to the plater.
Bar Plating in Meriden CT did the chrome plating except for the plastic. Plastic chroming in Miami did it, since he has moved to Texas
Taillights finished today
Originals housings send out and rechromed, Reflected paint on inside and pinstriped. Installed NOS lenses
Originals housings send out and rechromed, Reflected paint on inside and pinstriped. Installed NOS lenses
Trunk trim moldings. I bought NOS ones that where real nice but had some self wear and and a small dent. Sent them out to Tom in Ohio, he straightened and reanodized them. Installed the trunk moldings, taillights and the NOS emblems.
Thanks.
Unfortunately its been a long-long time and a lot work. It will get driven and beat on like all the rest of them. Hopefully soon
Last edited:
Installed the grills and front bumper finally. It’s been a little while that I’ve done set of 68 grills. A big recommendation is leave everything loose until it’s all in and adjusted, then tighten everything up.
Last edited:
hcallaway
Well-Known Member
Cuda is like a piece of Jewelry!!!!! Way too nice.
Small issue. Bleed the brake and the proportion and valve was leaking. I could not get it to stop leaking. I had to pull the header out and take the valve apart. I had to machine the top so the brass washer would seat.
Header back in. And brakes bled.
This has been a long journey. Finally pulling it out of the garage under its own power for the first time. lol I have to figure out how to download the video. Here is a couple of pictures on its first row test.
ON THE ROAD!!!!!!!!!
-
