727 parts needed for RB install in a 69 barracuda

[grjammer]

Looking for more information on the console shifter lower torque shaft bracket. I currently have a 904 on a small block installed. I have a 72 727 for the RB I am installing. It does not have any levers or brackets installed.
Current research indicates the only things necessary for the swap are the lower bracket and drive shaft.
Any input on this and possibly a source to find the correct bracket? The attached picture is the only one I have found, and does look like the bracket I have on the 904.
Thanks in advance.

 

[plymouth67]

Does your 727 have the correct extension housing on it to accept that bracket? Not all of them have provisions for the bracket.

 

[Lefty71]

Does your 727 have the correct extension housing on it to accept that bracket? Not all of them have provisions for the bracket.

I think i have a tailstock that has the bracket, but i split it while driving out the yoke bushing. I wonder if it could be welded in place on a non-bracket tailstock??