[WANTED] A Body mopar performance subframe connectors

-
10 foot of 1 1/2 x 2 1/2 rectangle stock and make them, You get enough to make the ends for the front and the caps for the rear. I am making another set here for a customer next week. Material was a little over $100
 
Oldmanmopar said:
10 foot of 1 1/2 x 2 1/2 rectangle stock and make them, You get enough to make the ends for the front and the caps for the rear. I am making another set here for a customer next week. Material was a little over $100
Click to expand...
Could you email me a picture of a set you've made? That would work awesome if so!?
 
If the Barracuda is on the lift I will take one tomorrow . I have not been over there. I have the material in this shop and the body on a rotisserie to make a set. I'll take some pictures of that process for the site when done.
 
For those of us that don't have metal fab skills, I bought these Competition Engineering connectors. They seem to be the same as the old Direct Connection ones that I bought from the dealership back in the day. Edit: Yes, they will be welded in place.

www.summitracing.com

Competition Engineering C3115 Competition Engineering Bolt-On Frame Connectors | Summit Racing

Free Shipping - Competition Engineering Bolt-On Frame Connectors with qualifying orders of $109. Shop Subframe Connectors, Bolt-On at Summit Racing.
www.summitracing.com www.summitracing.com

1732534255113.jpeg
 
Fab skills ???... it's basically a one by two strait peace of steal tube...
Bolting them on is a joke... they should be welded in eventually anyways...
 
IMG_4457.jpeg
IMG_4458.jpeg
IMG_4459.jpeg
IMG_4460.jpeg
Sorry bout the bad pics. I cut the tops off of the back to the contour of the floor. Split the corners in the rear, over measured and capped the rail. Welded a flange on the front with some holes for plug welds in it, as well as perimeter
 
You must log in or register to reply here.
-

Back
Top