Bottom End Shocker Build

[Rat Bastid]

What are there so many bolt holes on the end of that crankshaft?

I can’t remember if that’s a dual bolt pattern for 6 and 8 bolt flywheels or if that second pattern is GM.

It‘s one or the other.

 

[a-bodyguy]

240 ish@50 550 lift
250 shot
big block with blower torque

 

[RAMM]

I can’t remember if that’s a dual bolt pattern for 6 and 8 bolt flywheels or if that second pattern is GM.

It‘s one or the other.

2nd pattern is for (choke it back...swallow hard) using a GM flywheel/flexplate. J.Rob

 

[Rat Bastid]

2nd pattern is for (choke it back...swallow hard) using a GM flywheel/flexplate. J.Rob

I knew it was of the two. I was too lazy to go get the book and look it up lol.

Thanks

 

[67autocross]

240 ish@50 550 lift
250 shot
big block with blower torque

I have a few big old solid lifter cams laying around…I’m going to put the biggest one in it for dyno day

 

[67autocross]

Caps all fitted and lined… this block ended up 40 over … will do a mockup assembly and cut the deck… ordered everything else to finish…accept push rods and it all showed up in a week… nice to be able to get parts again

 

[67autocross]

Okay the thing is basically together…who should I go to for the cam and lifters…

 

[Rocket]

Quite a few good places to call and share your build spaces and car information with and see what they have to say. Jones Cams, Bullet, Racer Brown and Schneider are a few that come to mind.

 

[rumblefish360]

What he said ^^^^^^^

 

[67autocross]

We a local Isky rep here in Winnipeg…might see if they can do a custom grind