Be careful of metal shavings getting under the jig saw base plate cutting through the tape and into the hood.As far as hole cutting I just tape over the entire area and use a jig saw.
Be careful of metal shavings getting under the jig saw base plate cutting through the tape and into the hood.As far as hole cutting I just tape over the entire area and use a jig saw.
This is true the rubber seals that go in th e4 inch holes control the water from getting in under the hood save for a mist or droplets etc.I haven’t seen plates but the gasket that goes around the hole will stick up about 3/8” above the surface of the hood which should keep surface water under control.
Thanks, I'm not sure I would have thought about thatI haven’t seen plates but the gasket that goes around the hole will stick up about 3/8” above the surface of the hood which should keep surface water under control.
Me neither.I don't have any holes in my hood and I have the scoops. Zero issues with the studs breaking or the bracing.
View attachment 1716303596
Maybe you guys aren’t driving your cars fast enough?
A dumb question, I'm not aware of
Any plastic plate/cap to keep water from dumping in the engine compartment on stock scoops, but I have seen others that do. ???
Anyone know the going price for a flat hood vs scoop hood?