Sheet Metal Intake

[Danny Bellmore]

I'm looking at a sheet metal intake. I have a super victor ported by PBR that i have been using.
Do sheet metal intakes perform well?

 

[360duster]

usually all out racing stuff....and pricey. If i´d run such an intake i´d use the 2x4 top plate. Is it done by hogan´s for a LA Head or W stuff?

Michael

 

[Danny Bellmore]

usually all out racing stuff....and pricey. If i´d run such an intake i´d use the 2x4 top plate. Is it done by hogan´s for a LA Head or W stuff?

Michael

Its done for la stuff.

 

[Oldmanmopar]

That will only work good with the dual 4bbl plate where it draws directly down each runner. The dual 4bbl plate looks thin like it was a home made after thought for 2 dominators after the single 4 didn't work that great.

Here is a plate that has reinforcements for the carbs welded in under the risers.

 

[TT5.9mag]

If that sheet metal intake is for LA (not W) heads it will most likely be better than any head you put below it. In any configuration.

 

[RustyRatRod]

I'd say it depends on what's under it. Id PBR (RIP) ported the one you have now, it's probably a pretty damn good match for what you have.

 

[Newbomb Turk]

I’d bolting that on so fast you’d have to air mail me shorts.

That manifold will kick the crap out of any single 4.

 

[TT5.9mag]

I even like the single 4 top with the pent roof. I bet it works. That’s really the only way to get a single 4 to work on a tunnel ram. Hogans knows their ****.

 

[Danny Bellmore]

My current set up.

 

[Belvedere2]

I had a Victor W2 with a cooling setup like that. Had reverse cooling that ran through the center freeze plus as well. Never should have sold it. Live and learn.