I'm looking at a sheet metal intake. I have a super victor ported by PBR that i have been using.
Do sheet metal intakes perform well?
Do sheet metal intakes perform well?
Sheet Metal Intake
- Thread starter Danny Bellmore
- Start date
-
360duster
Well-Known Member
usually all out racing stuff....and pricey. If i´d run such an intake i´d use the 2x4 top plate. Is it done by hogan´s for a LA Head or W stuff?
Michael
Michael
Its done for la stuff.
That will only work good with the dual 4bbl plate where it draws directly down each runner. The dual 4bbl plate looks thin like it was a home made after thought for 2 dominators after the single 4 didn't work that great.
Here is a plate that has reinforcements for the carbs welded in under the risers.
Here is a plate that has reinforcements for the carbs welded in under the risers.
I'd say it depends on what's under it. Id PBR (RIP) ported the one you have now, it's probably a pretty damn good match for what you have.
Newbomb Turk
Well-Known Member
I’d bolting that on so fast you’d have to air mail me shorts.
That manifold will kick the crap out of any single 4.
That manifold will kick the crap out of any single 4.
My current set up.
Belvedere2
Well-Known Member
I had a Victor W2 with a cooling setup like that. Had reverse cooling that ran through the center freeze plus as well. Never should have sold it. Live and learn.
I run the VR 200's.
Would you run it with a single or a double?
Newbomb Turk
Well-Known Member
Two fours. Always.
TT5.9mag
Two atmospheres are better than one
That’s about as good as you can do for an LA head.
-
