Stop in for a cup of coffee

-
Trying to figure out the actual fan center to get shroud centered . this is exactly where the fan is centered on rad. 17 inch fan with 1 inch gap

20210819_092538.jpg
 
So impala, abs problem.
Had a harness connector, and used it as a consistent connection. Then voltmeter across the 2 wires on gator clips. Then pulled and twisted harness up into engine bay. No drop in voltage.
Ordered new bearing. Not even5,000 miles since i replaced that bearing,again!!
Fn junk. Bonus is it didnt need a swinging press to remove it.
 
Trying to figure out the actual fan center to get shroud centered . this is exactly where the fan is centered on rad. 17 inch fan with 1 inch gap

View attachment 1715783565
I woulda installed rad,took pencil and traced around on cardboard with fan blade as i turned it. Add 1” to diameter Measure between rad and 1/2 way into pitch of fan. Build box out of steel.
 
I woulda installed rad,took pencil and traced around on cardboard with fan blade as i turned it. Add 1” to diameter Measure between rad and 1/2 way into pitch of fan. Build box out of steel.
Kind of how I did it.....except for the steel part...
 
So guys. Who made a slant engine with 4 cylinders? Quite a car it was in......DeLorean, was involved...
 
-
Back
Top