Stop in for a cup of coffee

-
Good morning, time to get mr. Colgate out and brush my teeth and have some coffee.

20220718_195925.jpg


20220718_200204.jpg
 
Man that case of caps will be here today, no idea where to put them have the after Carlisle Mopar bomb that went off in the shop! Inventory of distribs suck doing it alone!
 
Last edited:
:rofl::rofl::rofl:
My neighbor across the street is Mitch. We give him such a bad time. When he was setting up his new cell phone message he had a cold "Hello this is *****. I can't pick up the phone right now............................" :rofl::rofl:


You guys should call him Mitch the ***** from now on.... :lol:
 
I'm a little sore today. Ribs on the left side. I was checking a fan noise on the Widow lady's car across the street yesterday. 03 Mitsubishi Galant. Knew it was trash or mouse house in the housing. Way up under the left dash. Only three screws holding it in. But the one in the back closest to foot pan could not bee seen. Only got it out by feel and assorted tools. Took an hour and a half just to get it out while laying on my left ribs in the door jamb...:mob: :wtf:


We need to make a pile for sore body parts from all of us in the coffee thread...

I bet we could build a Frankenstein with all of them...
 
Got the back wall pieced in and put some mud at lower where it can be seen if you look under the vanity. Nothing fancy there, Molding will cover half of it, but didn't want to see the edges of the patch panel. Also ran another coat on the side wall that I could still see a dip at the patch. Then on to the car... While at Carlisle I was getting stuff out and splashed Powerade on the seats and console. Didn't think much of it at the time. Most of my buttons were sticking and I could see little spots of sugary goo along the edges. Was able to use the back edge of the knife to clean out and all are working. Otherwise, did find how to take all apart and clean them. I figure that will happen eventually, but all good for now.

View attachment 1715961441

View attachment 1715961442


My son has a steamer that is good for things like that...
 
We need to make a pile for sore body parts from all of us in the coffee thread...

I bet we could build a Frankenstein with all of them...
Hey, the good thing is we're all doing what we're doing and not just sitting around collecting dust!!
 
Hey, the good thing is we're all doing what we're doing and not just sitting around collecting dust!!


My friend Danny had a baseball cap with the saying, "Ashes to ashes, dust to dust, if it wasn't for women our peckers would rust"...
 
Hmmm. I’m sure they have a lot of good uses. But don’t think that would be good for this. Would likely end up with condensation in bad places. The buttons go down to a membrane over the circuit board like a remote. Could probably vac it out that it wouldn’t get to the board. But the center multifunction switch and a couple others would get steamed in the process.


Steam on one side, shop vac on the other...

Suck and blow.... (That's what I tell her...)
 
Went to the doctor dry needling is like magic!! I have a Grade 2 hamstring pull.
No running or lifting for two weeks go back Friday for another treatment.
Went home told Cheryl no laundry baskets, no emptying the dishwasher, etc...
She wasn't amused and I won't repeat what she said :eek:...my ears are burning!!
Any way all is good here now we just have to hear Eric's results.


It's good to have doctor's orders to get out of honey do list and household chores... :D
 
-
Back
Top