Agree, finally got around to some back reading, nice tree and you're not fitting a bigger one in there, love it!
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
- Joined
- Mar 17, 2018
- Messages
- 14,737
- Reaction score
- 34,393
Grandsons are made for dogs!
Morning
Great pic, looks pretty comfortable!
What's going on today Ray? Did you come up with an Alt?
Guy says he has one pics to follow hopefully
I never got a moment to check the two I have Ray, hope and try looking at them today after I run my wife to breakfast and see her brother for a quick visit.
34 outside this morning, high of 51 and sunny, cup number 3 is empty, water and a banana next so I can take my morning meds.
66 quarters for Victoria on wait, front-end Aline and oil filter adapter remove and see why its leaking, bet I didn't get all the arigenal gasket off good..
34 outside this morning, high of 51 and sunny, cup number 3 is empty, water and a banana next so I can take my morning meds.
66 quarters for Victoria on wait, front-end Aline and oil filter adapter remove and see why its leaking, bet I didn't get all the arigenal gasket off good..
They both look warm and cozy
Morning gang.
Parts store run... going to put a new oil pump in the 318. Need to fire up the heater in the garage. 22° this morning
Parts store run... going to put a new oil pump in the 318. Need to fire up the heater in the garage. 22° this morning
Don't forget the Vaseline to pack in the pump
Good morning All, time for some coffee
Planted those 2 new trees up front, replaced deer blasted cedars with leyland cypress. Today I pick up my green vinyl coated fencing so a little more work to do and they're done.
Yeah I’m trying to not destroy it haha.impact screwdriver. from harbor freight will do you just fine. If that wont get it use a 9mm. or 30-06.
26 degrees at 0530… 24 degrees now at 0730, where am I? Nice an toasty in my little deer blind. Cannot believe how warm this thing is, no heaters, just half inch thick high density foam insulation under the 3/4 in plywood. Even with the windows open on all 4 sides.
candle wax will do it
Morning all . 20 degrees here this morning . Yikes am i in
North Dakota ! (Fred)
North Dakota ! (Fred)
Diagnostic equipment Vintage
Vintage oscilloscope and digital volt meter on rolling stand. Unit works with leads but I dont use it, and it is taking up space in my garage. Perfect for working on your vintage hot rod ignition...
www.facebook.com
Morning. Breakfast and some eggnog.
Meds then out to finish the Christmas lights .
Meds then out to finish the Christmas lights .
Morning!
Milder this morning, just a few degrees below freezing. And i was informed i need to take truck to the city, moving day for my daughter. Im not lifting anything. Tie load in and drive to new place. Rinse and repeat.
Milder this morning, just a few degrees below freezing. And i was informed i need to take truck to the city, moving day for my daughter. Im not lifting anything. Tie load in and drive to new place. Rinse and repeat.
OK Mike. I'm not smart enough to know if you're pulling my leg or if that's an actual "thing"
helps prime it. also make sure it is aligned right, seriously the holes can be a bit off on the passages to the block.
Thanks Hop... I was going to prime by hand with oil but if that's a cheat code, then cool
If your going to prime it when the pan is on your fine.
FISHYPETE
Well-Known Member
Maybe a Screech Owl?
-
