Unconventional
Well-Known Member
Some time between sunset and midnight, Elon is supposed to launch that Falcon 9 they sheltered during the thunderstorms the other night.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
dukeboy440
Well-Known Member
Not sure.
However, they found the problem. The meter base is bad, has to be replaced. On my dime by a licensed electrician
Unconventional
Well-Known Member
Anyone happen to have a 69-77 neutral safety switch for a 727? I keep reading the new ones are junk.
Bought a new one for my 904 and yep, junk.
dukeboy440
Well-Known Member
I can check but I think the one I have is from my 64
it needs to be the later one 69-77 as the pins and connector are different.
Should be the top one in the second pic. Picked up some NOS a few years ago unboxed.
There are two contact lengths for the rooster comb thats the big one calendar Boy!
Can't recall where I got the last one. Usually I walked into a transmission shop I had some dealinhgs with and asked for one.
Totally agree. Thats why I search high and low for the pre 80 stuff.
@halifaxhops I know you are into ignition but old senders and switches would be good as well.
Setting and standing this morning, legs moving and neck stretches, tried to touch my toes but elected to just grab my ankles... might grab a pencil this evening and ad another picture to my creative book, yep, I can be a bit crazy at times
Eric I am sure I have one 30 to your door?
Mike Tommy at Parts hound I give all switches to. Some senders I just get with ign parts.
Mike Tommy at Parts hound I give all switches to. Some senders I just get with ign parts.
So.. i need to make seat belt mounts for my car as it didn't come with any... i see guys using just a bolt and big washers.. but i was thinking of doing like a 4x4" plate with holes in it and plug welding it to the underside of the floor.. am i overthinking? also.. what bolts do seat belts use 7/16-20? Also.. need to find some gray seatbelts 
When it comes to safety, overkill is better than getting killed!So.. i need to make seat belt mounts for my car as it didn't come with any... i see guys using just a bolt and big washers.. but i was thinking of doing like a 4x4" plate with holes in it and plug welding it to the underside of the floor.. am i overthinking? also.. what bolts do seat belts use 7/16-20? Also.. need to find some gray seatbelts
bolts I have seen are shouldered so they can rotate. Might have a few used in the bolt can
Yep, a must do and don't forget those steat Bolts, they need a good reinforced area to hold you in place
Me as well, lap belt over a 66 Barracuda buckets.Since i can only run a lap belt i'm gonna eat a steering wheel no matter what... my goal will be to not hit ****
-
