VR-200’s…… AGAIN…….

[MOPARMAGA]

Isn't corrected just a way to compare results across dyno's?

Basically it's a number set to a standard pressure temp and altitude if I remember correctly

 

[NC Engine Builder]

They're not bogus they're best case scenario

Trust me, they are often bogus. And on purpose for certain shops.

 

[MOPARMAGA]

Trust me, they are often bogus. And on purpose for certain shops.

I don't doubt it.

 

[PRH]

Corrections for atmospheric conditions are a necessary evil for dyno testing comparisons.

 

[NC Engine Builder]

Corrections for atmospheric conditions are a necessary evil for dyno testing comparisons.

True! But it's a eye opener to see a pull with the correction factor just under 1 percent, and then it reset to 10% for the "hero" pull

 

[74 Cuda]

This is another test engine that I built to prove our VR-200 cylinder headsC

Can you share some head information? I'd like to see the flow numbers at .400", .500", .600" along with the intake valve diameter, throat dia or % and the port length and CC's if possible

 

[fishmens67]

I'd like to see the flow numbers

I already asked, I understand why he won't show them, probably doesn't want to get into a flow bench battle with the naysayers.
Some things are better left to themselves when it comes to custom work.

 

[74 Cuda]

I already asked, I understand why he won't show them, probably doesn't want to get into a flow bench battle with the naysayers.

Some things are better left to themselves when it comes to custom work.

No arguments here just wanted to crunch some numbers. All good