What do I have..?
- Thread starter nodemon
- Start date
-
junkyardhero
Well-Known Member
833 from december 1971
ETA: 046 would be the 46th unit built that day
the #'s on there look a mess
ETA: 046 would be the 46th unit built that day
the #'s on there look a mess
Look a mess..? In what way..?
Anyway to tell if it's an a body trans. ?
junkyardhero
Well-Known Member
the upper (vin) stamping looks sloppy.
bigger pic will tell if it's a body. shifter location/tail shaft
bigger pic will tell if it's a body. shifter location/tail shaft
Abody-
junkyardhero
Well-Known Member
dig them crazy rods!
Heavy duty..?
junkyardhero
Well-Known Member
nah, they's home made. somebody saw a ramrod shifter and said: i can do that! minus the whole shifter part.
Scody21
Just send it
Must have been one hell of a hack job to the cross member…
junkyardhero
Well-Known Member
as evidenced by the rods... they have a welder so no big deal, right?
Not sure what you mean.. These rods are no good..? I should buy some different ones..?
Scody21
Just send it
With a transmission in the stock location and using the “straight” / super stock rods like the homemade one you have, you have to cut up the frame side and bolt in part of the cross member to make it fit.
Scody21
Just send it
If you’re using in a stock application, you would be better off buying / finding a set of “A” body shifter rods as the angles / bends are different. If cutting up, those would work.
Good info, because I had NO idea.. Would have been bummed when installing and running into that issue. Maybe Brewers has them..?
Again, thanks for the info.
Scody21
Just send it
I bought a set from these guys years ago. Hurst 3 & 4 Speed Manual Shifter & Linkage Replacement Parts
Brewers may have them.
Brewers may have them.
junkyardhero
Well-Known Member
i think classic or PG may have them as well
Scody21
Just send it
You may find that pistol grip shifter to be too long / tall and not a comfortable reach in an A body. If I remember tomorrow I’ll take a photo of the number on the one I have in my car.
junkyardhero
Well-Known Member
ohh! looks like you'll be able to change the radio in 1st & 3rd!
It's the one that's "recommended"...
Shift handle will be fine, that's the non-console 71 B body shifter. It doesn't hit anything. The handle is a smidge high if you're running factory bucket seats, but it's in a better spot than any of the stock pistol grip alternatives. This is a picture of the same handle in my Duster when I had an 833 in it, it's almost certainly in 1st gear here so it's all the way forward.
-
