Recent content by Luc

Just for your information, those are analog cameras, 0.5 megapixels. IP cameras are usually 3 or 4 megapixels.

I think wouldn't be possible, since there is no additional lever in the lock that could be pulled to unlock. Universal kits are made for 90+ cars, and from around those years, laws required the latch to have a way to open it from the inside. But like 66Dvert suggested, I will try to find a 198x...

To make a long story short, a few brands have IP cameras that communicate on bnc/coax with their prioritary dvr/nvr. The main advantage is to save on wiring, and the same dvr can support old analog cameras as well as their new coax/ip cameras. Hikvision calls them TVI cameras. Capped to 2mpx...

I was to install an electric trunk release but just noticed the flat rod from the lock cylinder to the mechanism can't be turned if there is no key in. And there is no other way to release the mechanism so I'm in a dead end with this...

I am in the process of installing an alarm and doorlocks on my 64 convertible Dart. The actuators are a bit tricky to install because those cars have less openings to work on the inside of the doors than the recent cars. I ended up drilling holes in the lower corner of the door to bolt the...

Ok good to know the contacts are still on the pcboard. However where is supposed to be the sending unit on that car/engine ? Do you think it was simply removed and replaced when the guy added the aftermarket gauge set ? Changing the voltage limiter is part of my plan, as I read how to do it...

I removed the cluster, and there are no wires attached to the bolts protruding of the temperature gauge. On the front of the engine, I have a sensor with a coil around it for the whole lengh of the sensor, but that one is going a sensor that was added under the console (see picture) That added...

Very Nice !!! Inverted colors :)

I paid 8000, I didn't mind various little problems, the important and expensive stuff (to my eyes) are the interior, the top, the paint, and no rust. I don't have the history of the car, I only know the owner I bought it from had it for 2.5 years and bought it in Ashland Kentucky.

Here's mine, bought it less than 2 weeks ago in Ohio. Beside a few small parts, minor electric problems and a leaking transmission, I just love it. 1964 GT Dodge Dart Convertible /6 904

Thanks for your "lights" :) there is no 12v on the fuse that has the orange wire coming out. But if I manually put 12v on the tan wire, the backlight works. I'm making progress. Next thing is to remove the swich and find out if it's a bad connection, or a bad switch. Thanks !!! That saved me...

Hi, probably a stupid question, but does that unit features an auto-park ?

That's correct, those are the diagrams I have. Thanks, I'll get back on that project in the morning. All exterior lighting works perfectly, but none of the cluster backlights. I have a light blue connector at the left of the steering wheel, but It looks like I'm missing the hand brake switch...

Title says it all ! I found the schematics for the 1964 Dart, but they don't detail what wires does what past the cluster connector... None of my bulbs are lit in the cluster, but I removed and tested one and it's fine. Thanks for any help !! I just got that car and already love it.

Thanks will do that !!