Recent content by mopar_1974

hey rumblefish! Ha I haven't been actively on here for a few years but I still remember you being a pretty active member here. This engine was the old engine out of 7172dusters car. It probably only had maybe 1-200 miles on it since I've gotten it from him. It was a long process putting in and...

Greetings All! Been quite a while since I've posted but had a quick question for you. A month or so ago I believe I blew the head gasket out of the 360 in my truck. (smoke, coolant through exhaust). I was planning on pulling the engine out and going through it this winter but I don't have the...

I had the heads flow tested a couple years ago but have since lost the spec sheet. Can't for the life of me even remember the numbers. The place was in Wisconsin... but that doesn't help neither one of us either.

Casting number is 4027596. Have had about $1100 worth of head work including oversizing for 2.02 valves and valve job done years ago. Have been sitting for a bit so could use a bath in the hot tank but should be great heads I would think. Asking $650 obo +shipping from Minnesota.

http://mankato.craigslist.org/pts/4420178967.html These are mine. You can call or text if interested. Not sure where you're located. Eric

2 Edelbrock 1406 carburetors for sale. One (pictured) was on my truck and running good. The other i rebuild and swapped out and is currently running on my truck. Also have the the 1487 tuning kit. Opened but never used available for $30 for whoever buys one. Intakes are both in good usable...

I need brackets for A/C compressor. Must work with intake with thermostat housing in center. Thanks!

Any feedback on the holley? http://www.summitracing.com/parts/hly-0-76751bk/overview/

the motor is .030 over with venola 8.5 to 1 compression. stock recon rods with arp bolts. the crank has been ckecked dont rememember if its turned. clevite bearings through the whole thing. it has a windage tray and milodon pan. the heads are ported 915 j series with 1.88 int 1.69 exh comp...

Thanks for the responses guys. 5 replys with 5 different carbs. Which tells me at least to get the carb off and choose something else. (At least that's what I think you're getting at?) Also, I forgot to add something. This motor is now in my 1984 W350 Ram, so the weight and gearing is quite a...

I would love an Air Gap but I need an intake with an offcenter thermostat to clear my A/C on my truck and I had the performer lying around. Might be interested in the QF. Haven't heard of QF before though. Gonna have to do some reading up I guess. I've got 3 carbs and 2 intakes lying around...

Hey guys. debating on a new carb. Here is the dyno sheet from my motor before i bought it as a long block. LA 360. Since, I have swapped the holley strip dominator with an Eddy performer intake. It has an Eddy 1406 on it now but i dont know if it's living up to its potential. Would it be wise...

I took the engine out of my duster and put it im my 84 ram. I swapped oil pans from center sump to rear sump. The engine has a windage tray. Will this cause a problem with the new pan? Also installed an oil dipstick (the engine didnt have one...plugged with sealant) but the oil doesnt even...

No... neither. the first time it happened was with the filter i ran all last summer with. I made damn sure I didn't double gasket it with the new one too. I dunno, not a big deal, its not leaking now. Just worries me that something might happen again.

no, just poured out of the gasket, and i made sure it was tight. it was fine all summer too with the first filter that was on it.