Recent content by VF69HARDTOP

Hi guys I just finished up my 904 build with a CRT-22X valve body and wanted to know if you must use a blocker rod in the accumulator or can you still use the spring? The instructions that came with are clear as it mentioned you go do either with the - 2X. Its a street car so wanted to keep...

Hi guy's Could someone please upload the instructions for the CRT-22X valve body as I've lost mine. I want to check what is written regarding the accumulator. Thanks

Those are Aussie guys here in Adelaide, South Australia where I am.

Out of interest, did you have the accumulator added back to the valve body to soften the shifts a little?

Can I ask what your car specs are that John suggested the 22x? I'm currently looking at the 2x and 22x but not sure what to pick. Car is a Aussie version of a 69 dodge dart with a turbo 318 making around 600hp at the crank. It's a 98% street car that will see the strip only a couple of times.

What clearance should I be looking to set it at? I see Cope sell a snap ring kit so will order this also.

Hi guys I'm looking to order a BIY 904 500hp rebuild kit from Cope Transmission and wanted to know if the 5disc clutch upgrade fits without any mods done to the drum in a 1977 A904? I've emailed Cope but not getting a reply and as I'm in Australia, the time zone difference makes it hard to...

Thanks for your thoughts. I'm also looking at the Pulsar S372 journal bearing with a .91 twin scroll exh housing. It seems to sit in between the 7875 & 6973 so could be a good match. What's your thoughts on this one? Thinking I might bring the power goal back to 700fwhp Max so hopefully help it...

If it fulls apart, I'll have to put a dirty LS in it hahaha

I'm hoping the engine will make around 400 fwhp and then add boost from there. I'm limiting boost to no more than 14-15psi,so it might make 700 ish fwhp, fingers crossed. But then again, I might decide to stop at 600 fwhp to help it live. My line of thought is that by adding boost, I don't need...

What's considered to be the weak point of the block?

Thanks. I have that oil pump on the shelf, just needs checking before installation. Do you know of anyone that's used a 7875 on a 318?

Hi A body 318 with 9:1 comp Eddie rpm heads Victor 340 intake Lunati solid flat tappet 2400 6600 RPM 235/243 Duration at .050". 110 Degree Lobe Separation Angle 0.526"/0.546" Valve Lift Holley sniper throttle body injection 2500rpm stall 3.45 diff gear Looking to make around 800FWHP but...

How does this turbo sizing look for my goal? AF8006-4016 - BOOSTED 6973.91 T4 TWIN ENTRY

I like the look of the 2058r grind. So a smaller duration on the exh is needed for turbo applications? Thanks for the info.