Search results for query: *

what is the initial timing on a 383

I have a 383 that I got rebuilt at a machine shop,,short version,,I wiped out the cam but I am now putting it back together and noticed that the rear oil hole for the cam bearing only has about 1/16 of the oil hole lined up with the cam bearing hole and another one only has about half the hole...

Its mildly built,, bored 40 over,keith black eliptical dome pistons with valve cut outs,comp cam part #21-222-4,,,,grind #crb xe262h-10,,,intake valve lift.462,,exhust lift .470. eddy performer rpm,,ported and polished 906's,,holly 870street avenger,,and engine is balanced,,Auto tranny.. It has...

It would seem that I might have lost a part!! I have a small piece of steel to put accross the back of valley pan but I can't seem to find what ever there was to put on the front of it and was wondering if it looks the same as the rear one

I am sending my block in tomorrow to the machine shop for the engine rebuild to start. Its a 69 standard bore with factory flat tops. There is no ring wear on the cylinder so I am fairly sure that it will only need a honeing. Now is it really worth it to bore it 20 over and put in a set of keith...

I'm just looking for the rough numbers on a 68 383,, Its bone stock,, its got 906 heads, has not run since 1974 except for when I tryed it out to buy it. I know I have to rip it apart to re gasket and seal it but I was thinking about doing a little bit of internal work while it was apart but I...

I have a 1968 383,,,I got a double chain timing set for christmas for a 3 bolt cam but he was told when he bought it that it might need a single bolt set. As far as I know this engine is stock,, is there a standard cam that these engines use.