Search results for query: *

Is there a right and left specific bracket for mounting the engine to the K member? When I tried to install my 318 block with 360 heads and tubular headers, the headers sit on top of the steering shaft. Even the stock headers seem pretty close to the shaft. Any thoughts?? fastmopar

WELL..... My 72 has been out in the driveway for a couple of single digit temperature days. I moved it into the Garage this last weekend then went out to clean up the driveway. A freeze plug was sitting there. The engine had H2O, no antifreeze in it. Had not progressed to the antifreeze level...

A few days ago I posted for some help with my Edelbrock Carb on my 318 I had just been able to get up and running. I received a lot of good input and it help diagnose the problem. The problem was actually timing. It was about 60 degrees too far advanced. Not sure how the engine even ran. I...

Anybody running a Performer on their small block? There are two vacuum ports on the front of this carb. Which do you use for the vacuum advance? I bought this carb at a swap meet so I didn't get an owners manual. Also, are you using the temperature controlled hookup? It's a tower thing that...

There is a half moon shaped slot (opening) in the heads over the center exhaust cross over. (This is the port that directs exhaust gas under the intake.) This half moon slot (opening) looks to be a water jacket in the head. If it is, then the Edelbrock intake I have dosn't cover the slot and I...

I just cleaned and reinstalled my lifters in the 318. They are dry, no oil. When the cam comes up to the top of the lobe there is absolutely no play in the lifter. It's like the hydraulic lifter is completely collapsed. Is this normal? I checked the dry lash and it is in spec (.060 - .210)...

I started my engine last night after 3 years of sitting partially done. It's an overbored 318 (.060) with 360 heads. I matched lifters and push rods to the heads (They came from the 360). Once we got fuel to the carb...... it started right up. Idle was a little rough, probably due to...

Just cause I'd like to hear your opinion.... And find out if anyone else has this combo...... 318 from a 69 Dart, bored .020 over, with R & R'd 360 heads, Edelbrock aluminum 4bbl intake, Edelbrock 750cfm Performer 4bbl carb. Unfortunately stock headers for now. A/C delete and fan delete. Let...

I have a .020 bored 318 with 360 heads. The aluminum Edelbrock Intake leaves a gap in thecenter of the head. It matches the contour of the intake runner. Not a hole in the intake runner. This above and surrounding the runner. Is this normal? Will it leak coolant or oil? Do I need some sort...