Search results for query: *

whos done it. i want to turbo a 360. what turbo, bov, waste gate did ya use. i dont know the first thing about how to pick a hair dryer. im a welder/fabricator so all the fab work is right up my alley.also lets see some picks if ya got some.

I was just wandering what everyone else thinks the power potential is of an 410 stroker. i have a built 360 i want to stroke to a 410. i will be going with flat tapped solid. these r some parts i have and would like to reuse. hughes %100 cnc ported eddys hughes roller rockers 1.5 stock 79 la...

lunati solid flat 30200741 aka 60441 any body run this cam? i just bought one for my 360 and just wanted to know how it ran? Lift .546"/.566" [email protected] 243/251 LSA/IAC 110/106

heres the motor motor is 360 .040 %100 cnc ported eddy head byhughes 10:5.1 comp lunati cam solid flat Lift .546"/.566" [email protected] 243/251 LSA/IAC 110/106 lunati lifters hughes roller rockers eddy rpm air gap intake holley ultra 750 double pumper eagle floating sir rods kb flat top pistons...

hope the pics are nice

360, 040 over 10:5.1, rpm intake, hughes rockers, 30200741 comp solid flat cam tti headers, holley red electric pump, electric fan, fully ported 2.08/1.60 eddy heads, holley ultra 750 double pumper. OK, wait i just found a new lunati solid flat #30200913. it says "Solid, rough idle...

i m going to be switching out to a little bigger cam this winter and want to see what you guys think would be the better choice. the xe285 or the biggest of the voodoo series hyd flat tapped. la360 holley ultra dp 750 eddy airgap hughes cnc ported eddy heads, 2.08 intake 1.60 exh hughes...

this is my combo la360 holley ultra dp 750 with 72 jets eddy airgap hughes cnc ported eddy heads, 2.08 intake 1.60 exh hughes roller rockers 10:5.1 kb pistons eagle rods stock crank tti headers 2.5 x pipe electric cutouts flowmaster 40 series 727 dana 60 with 373 3200lbs duster need to get a...

i built a 360. i run pretty good. the engine builder told me the cam i picked is a little small for the heads i got. i was thinking of changing for a bigger one. i need help deciding on the best cam for my setup to make the most power. please help me out and give me some options. mostly street...

i finally got a timing light check on my fresh 360. it was at 60 degrees at 3200. very embarrassing. put it back down to 35. i didnt even relize it could run with it that high or know that it was for the past 50 miles.

I was thinking about changing the springs in my mallory distributor and I am looking for some helpful advice. Has anyone done this? What kind of results did you get? My goal is more bottom end power.

i was out adjusting my carb and i reved up the motor a few times to clear out the carb for float adjustment and then the oil pan gasket started to leak and smoke oil off the headers. so i quickly shut it down thinking i blew a gasket. i started it back up and at idle no leak. i reved it a little...

i just finished my 360 build. i did not have any money left over for dyno time so i dont know what it makes as far as #s. i was wanting some help trying to estimate flywheel hp and torque. specs are as follows.from top to bottom. holley ultra double pumper 750, stock out of box eddy air gap...