Search results for query: *

Be it LA, Mag, or gen 3 Hemi can be applied to either and/or all 3. So the question is what kind of stroke (biggest) can they handle, which I already know there is a 4.250 stroke crank out there but what about a 4.5 or 4.75 hell even a 5.00 stroke in them? Is there massive interference with the...

I do remember that some said it couldn't be don't but here you go. A stud girdle and a crank scraper (up and down with Teflon blade) all in the milodon road race oil pan.

Ok I'm curious on what my motor will make/produce, and I've been hearing from a range of 350 to 450 HP(nice range but want a narrower scope) and I want to know what you guys think it will make. So here are the specs. 340 (Sonic and mag tested 72/73 block came for a Cuda) 4.070 (.030 over)...

I'm wanting to run a remote filter setup on my 340 in my Duster. Who makes the best system/setup and should I run a single or dual filter setup? The car is a street/strip setup (but probably will only see the track once or twice) running full synthetic oil with a new stock oil pump and the...

Ok after dealing with this thread about pushrod angle http://www.forabodiesonly.com/mopar/showthread.php?t=131950 , I need a set of aluminum heads. So who makes the best aluminum heads? Need to know ASAP. Thanks.

Anybody have any problems with roller lifter and the pushrod angle to Roller Rocker arms? I've done this (roller setup) before in GMs and Fords and not had this problem, anybody got any ideas on this one

What are the w8 heads? How do they compare to the w2 heads? Any info would be great!

I have a set of comp roller rockers on x heads with stock 1.5 ratio and stock valve lift. Question is anybody using these under stock height (3.75 inches) valve covers? Need to order my valve covers but they are special order so either I get stock or tall (5.75 inches) so need to order right...

Anybody here using a crank scraper? I'm looking at getting crankscraper.com Teflon version for both up and down stroke and was wondering if anybody has used the Teflon version yet and what they think of it.

Who makes a better product COMP or Crane? These are my two choices not sure which one to pick. Need to know ultra quick! Thanks in Advance. http://www.summitracing.com/parts/CRN-69532-16/?rtype=10 Crane http://www.summitracing.com/parts/CCA-8920-16/ Comp

Is the bolt pattern on the motor of a 340 the same as a 5.2 or 5.9 (MAG)motor for all the brackets? Basically I want to use the brackets for the MAG motor and put them on my 340, so I have a serp belt setup (can score everything minus the a/c pump for 85 bucks) anybody ever try this?

Are X-Heads closed or open?