Speedotann
Well-Known Member
Thanks Brian,
I will be getting in contact w/ you after the Holidays HOPEFULLY!!!
Brian
I will be getting in contact w/ you after the Holidays HOPEFULLY!!!
Brian
Brian,
I hope you didnt take my post about the size of the cam as disrespect because it wasnt intended that way. I was simply asking a question to learn more about motors.
I have asked you several questions on websites and by the phone and have ALWAYS been respectful. I try and learn from people like you.
Mike
Does anybody know how much it would be to ship an engine clear across country from Michigan to California ? Long block , short block ?
Brian at IMM custom ground the hydraulic roller cam in my 414 small block. Engines been in my car for almost two years now and it still thrills me every time I take it out. Instant throttle response,tons of low end torque, and screams on the top end like it wants to rev forever. I've scared a lot of passengers too. I always get compliments on how bad *** it sounds at the cruise spots. Definately a great guy to work with who was answering emails and providing expert advice long after I bought the parts. His prices were great too and he always shipped out very quickly.
Does anybody know how much it would be to ship an engine clear across country from Michigan to California ? Long block , short block ?
Nice to see some can't help but be a pot stirring Dbag....
Yes, you're still on ignore stroganoff340, you find the missing MPH?
Your such a douchebag,on your ignore list but yet you still come on here addressing me,ignore this homo:thebirdm::thebirdm::thebirdm:
I purchased a 415 smallblock storker off Indy Cylinderhead in 2004 for $2950. It was a short block assembled with a internal balance, mopar performance cast crank, SIR rods, Weisco pistons, pump gas engine. I asked them for a cam and they selected one for me and said the engine would make 450hp with my eddy heads. I had some head work done to raise comp to 10.2 to 1. Car has had 100's of passes in it's 6 years of use and has ran 11.34 best but usually runs 11.45 to 11.50's. I've been very happy with it needless to say. I drive this car alot during the summer months and do the local cruise nights here in Michigan also so it has plenty of street miles on it. Jayson
Heres how I look at it,
Rotating assembly from Muscle motors or wherever $1,200
Indy RHS Heads with 2.02 Valves 1,200
Block work 500.00 to 1,000 (if that) 1,000
Misc.... cam Oil pan intake carb 2,000
You can get one built alot cheaper than 7,000