My Trailduster Search Is Over

-
Been making some headway on the Trailduster lately.

Painted the front frame rails, just to clean up the engine bay appearance...
IMG_20220831_215323411.jpg


Had to fab up a place for all of the Holley Sniper electronics and components to go, so I'm using the spot where the original heater box was (since I'm running an aftermarket unit inside the cab).

Laid out my pieces, then drilled holes, primer & paint, and installed...
IMG_20220829_211940315.jpg


IMG_20220905_215010147.jpg


IMG_20220908_192245629_HDR.jpg


After that, started installing engine bay accessories and cleaned up the wiring...
IMG_20221210_150709709_HDR.jpg


IMG_20221210_231704924_HDR.jpg


I also installed a reverse indicator light. Not in the factory spot, but I like it here...
IMG_20230106_210731987.jpg


IMG_20230107_172821866_HDR.jpg


IMG_20230107_172856394_HDR.jpg
 
Been making some headway on the Trailduster lately.

Painted the front frame rails, just to clean up the engine bay appearance...
View attachment 1716032792

Had to fab up a place for all of the Holley Sniper electronics and components to go, so I'm using the spot where the original heater box was (since I'm running an aftermarket unit inside the cab).

Laid out my pieces, then drilled holes, primer & paint, and installed...
View attachment 1716032793

View attachment 1716032794

View attachment 1716032795

After that, started installing engine bay accessories and cleaned up the wiring...
View attachment 1716032796

View attachment 1716032797

I also installed a reverse indicator light. Not in the factory spot, but I like it here...
View attachment 1716032798

View attachment 1716032799

View attachment 1716032800
Any chance you could put the sniper stuff on the inside instead of in the engine bay side??...
 
Any chance you could put the sniper stuff on the inside instead of in the engine bay side??...
I suppose that's possible, but I would need to move the aftermarket heater that is currently on the other side of that panel. Plus, one of those pieces is the Holley Hyperspark coil, so the coil wire would need to pass through the firewall to the distributor. Which I guess could be done.
 
I suppose that's possible, but I would need to move the aftermarket heater that is currently on the other side of that panel. Plus, one of those pieces is the Holley Hyperspark coil, so the coil wire would need to pass through the firewall to the distributor. Which I guess could be done.
Just trying to think of ways to help you tie things up a little under the hood. I didn't aftermarket heater on mine but it didn't take up very much room it's kind of small. I went big with my AC as I mostly drive it during the summer... I just wasn't sure what you had on the other side of that...
I'm big on trying to hide everything I can..
 
Been driving it lately, since it hasn't been so hot in Texas... still need to finish the black paint in the middle of the grill

1731695119474.png


1731695149282.png
 
-
Back
Top