Drive shaft fits like a glove!
So no big spacer at transmission.
Next is settin pinion angle.again.
So no big spacer at transmission.
Next is settin pinion angle.again.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Ddaddy
Just doing what I do
Five 1965 Barracudas for $4k
1965 Plymouth Barracuda - cars & trucks - by owner - vehicle... - inlandempire.craigslist.org https://inlandempire.craigslist.org/cto/d/bloomington-1965-plymouth-barracuda/7116626547.html
1965 Plymouth Barracuda - cars & trucks - by owner - vehicle... - inlandempire.craigslist.org https://inlandempire.craigslist.org/cto/d/bloomington-1965-plymouth-barracuda/7116626547.html
I was looking at those.....Real close to me....Any one interested? Could work out getting them to whoever.....
zkx14
Duster De-ruster
Could be..
Maybe a little too cool for them yet. Some of mine are a foot tall. Others just starting.
I am so tempted for the red V8 one.
I could drop the 318 I have into in and resale it for some good profit....
zkx14
Duster De-ruster
Where the hell do I put them? My neighbors would go crazy I put all those on my place....Could probably have them all for 3K.
I bet they are all rust free......Could probably have them all for 3K.
zkx14
Duster De-ruster
hey now, that's my land, I'm buying that...
I wish, wife wont let me
Finally. Just going to tack weld it for now will finish welds when i swap in the gears -again!
Ddaddy
Just doing what I do
You might only need the red one and one other as a parts car. Would have to inspect them to know.
straightlinespeed
Sometimes I pretend to be normal
Is that the Tremec app?
Yes. I hate it.
straightlinespeed
Sometimes I pretend to be normal
Im in the same boat! I tried it and tried it and tried it 20 more times. Each time it was a different number. Finally I just at it until I got a consistent number for that spot.
And pulled cover with tape measure nearby. 8.25 ring gear. I have 3.55 sitting on floor.
Stupid thing is i wanted a diff,and stuck the first one in, but wanted to pull the truck one. All the grief i suffered was self inflicted.
Stupid thing is i wanted a diff,and stuck the first one in, but wanted to pull the truck one. All the grief i suffered was self inflicted.
It didnt like angle 1 as i set the trans level. Had 2/3 green then when i lowered it with the wheels on it accepted it.
Was just a pain going back and forth to find the happy spot.
If the app suggested the last measurement it would save a lot of bs. Then you could dial it in to top or bottom of the parameter.
Hello All. Found the Demon is leaking oil something terrible. Ugh. My thoughts are the timing cover or oil pan. Going to wipe it down, dump in some dye and run it for a bit and observe with a black light. I have a timing cover gasket set coming in tomorrow just in case. This sucks.
so its from the front area?
Well that didn't work. I was supposed to have a virtual exam with my Dr. over my phone but the program works with Chrome but not Firefox. It won't access my camera and microphone. (and I'm not changing browsers.) We'll do it on the computer tomorrow.
MomsDuster
Well-Known Member
Looks like my radiator flaps work, definitely some airflow where there wasn’t before. It’s kinda hard to see (was filming and driving) but look between the cap and air cleaner. We’ll see if the make any difference when I get the hood installed.
Holy cow, I dropped it off this time yesterday.
-
