Didn’t have one that went below 100 inch pounds.Have you tried for a Craftsman??? They usually carry them at Ace Hardware...
Didn’t have one that went below 100 inch pounds.Have you tried for a Craftsman??? They usually carry them at Ace Hardware...
Damn the Cummins injector bolts are 22 bucks a pop… for a m6x1.0 grade 12.9.
They won’t have them.
They won’t have them.
Well then... I guess you're really up **** creek...
Good question.For a grade 12?
Its why we chase all the female threads
That's a 12.9?
Threaded ones are easier to engageI chase all females whether they are threaded or not...
I ran a tap down thru the bolt holes and blew it out with the air gun. Twice. No I think it was a combination of the torque wrench not being accurate and me not quite having the feel for such low torque. I hung 35 pounds of known weight in 5 pound increments off the handle of the torque wrench before it finally clicked. With it set at 45 inch pounds.Good question.
Looking up the general recomendations on class 12.9 I see 12 to 13 ft lbs as the range published at internet sites.
So 144 in lbs.
Lets try thinking about other possibilities.
Do you still have the broken head?
Lets see a couple close ups.
Maybe it damage before you tightened it down, like a fracture.
Or maybe there was interference and the head wasn't contacting its mating surface.
Classic situation is junk at the bottom of a blind hole or a screw that is too long.
Its why we chase all the female threads
before bolting an engine or transmission together
Supposedly so. According to Cummins themselves.That's a 12.9?
Full threaded up to the flange?
just add to the reasons Carroll Smith disliked metric bolts
Stretched !????I ran a tap down thru the bolt holes and blew it out with the air gun. Twice. No I think it was a combination of the torque wrench not being accurate and me not quite having the feel for such low torque. I hung 35 pounds of known weight in 5 pound increments off the handle of the torque wrench before it finally clicked. With it set at 45 inch pounds.
I’ll get pics later this morning. The one just sheered in half, which actually is a good thing cause I wouldn’t have noticed that the other one had stretched and bent