Or from the beverly Hillbillies in there Bankers mopar he drives
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Going to be funny when I get pulled over for talking on the phone while driving!
Or they might want to take it apart looking for Pot
you know, that stash of joints you rolled up to take to the car show
I almost went to jail for having dried hops in a vacuum packed bags on the front seat
I remeber you saying that a year or two ago, that had to be a funny day after it was over
It does look like weed though....
Would a chisel on an air hammer work? or distort the metal too much?
Why say you that?
I would think an air hammer with the three poited cutter bit would be worth using..
Tried it easier with a chisel room wise.
Morning everybody.
Wondering why everybody is so early-but im an hour late.
Wondering why everybody is so early-but im an hour late.
They are spot welde to the front rails and the trans/torsion bar mounts. I should have it in today hopfully
I use cutoff wheel in die grinder,rough cut panel. Then carefullt remove remainder with chisel and a carbide burr
Can't answer that. Time zone?
Myself. I was up too late - here!
That thread went wrong in a few posts it is for the new guys that have tools just the basic new to Mopar tolls.
I went in and deleted some post's for you, I do understand what you are looking for , but keep me updated if I miss some, I fixed a couple this morning and added a tool
Lol gave up on it and un subscribed. Bet it gets over 100 opinions I mean posts.
Morning all. A spirited conversation this morning I see. Dang, my coffee is cold already. A lot of backreading.
Basically what I am doing. Just takes a lot of time.
Looking good Mike
Looks good. I hope to be that close before snow flies.
Now to locate a 360 to 904 flex plate and a harmonic balancer for the 360 and get moving towards getting her pipped up
76 dart ran a 360/904.
-
