Search results for query: *

Ok finally got the 416 motor running yesterday... Yessssss! I bought the block on April 17, 2010. So about a year for this motor project. But really more than just a motor project.... Motor's is really nice. Revs pretty quick for a 4" stroke too. The idle and sound of Comp 274S mechanical...

I just installed a Nippondenso 102mm alternator with ~50 amp advertised in my Barracuda small block with aluminum 70-up water pump and 69 down cast iron water pump. I tested it all last week on the current small block motor in my car with cast iron water pump (69-down). That was a temporary...

I tested out the MSD E-curve and the Denso 102mm alternator in the temporary 360 motor that is in my Barracuda last Sunday. The MSD E-curve was really too tall for an 67-76 A-body with 3 speed wiper. The wire boots are only 1/2" away from the wiper motor housing. To remove the cap or...

I'm dropping in one of these new MSD E Curve distributors. It is a real nice looking unit buy I have one BIG question. According to the directions that came with the distributor you "drop in the distributor with the rotor pointing to the #1 terminal on the cap and then tighten down the...

Bought these solid lifter but they were not in original packaging. Does anyone know what brand they are? The MP lifters are actually lighter and have a hollow core with insert. And the wide center cutout has us worried about lifter side support in a small block mopar. The pushrod pocket is a...

Looking for some thing under .030 head gaskets for my 416 build that will only be 10.2 to 1 or so compression. Most sites list the P4120094 .028 compressed gaskets at 4.06 bore, which will not work for me. But some list that as 4.125 bore which I think is incorrect. ?? What about these...

I've got a brand new M-1 single plane that is for a W-5 with the different intake bolt spacing (PN 4529460). I'm building a stroker with standard bolt spacing heads (ported E-brock). Can I have the bolt holes welded to make it work a std head bolt spacing? Anyone with a std head M-1...

I've been helping/bugging with Milodon on a small block Mopar pro touring/high capacity-stock height/road race pans similar to the other road race pans they make. Like the big block Mopar one they offer, pn 31580. Many people use that big block road race pan on their HiPo street cars to get a...

Well after tossing the number #6 rod bearing two weeks ago in the only car I own that runs, my 68 Cuda, I ran into an issue. I just found out the 340 block I got at Spring Fling has a rear main cap that will not clean up with an align hone. Anyone in So Cal with some extra rear main...