Search results for query: *

cruising down the freeway tonight i noticed a noise when accellerating from 2500rpm to around 2800rpm. sounded like a rattle coming from the pass side bank toward the back. my car is gutted so i can hear alot coming from the engine bay while driving. the noise gets a little louder at around...

i got a 77 360 engine out of a van i built in highschool for my duster. its stock comp, stock bottom end with a cam and some head porting. i also have a 99 5.9 magnum engine complete. my plans are to build a 408 stroker in the near future. my question is, which engine would be...

hey gang, i got a 77 van 360 engine in my 72 duster. stock bottom end, stock pistons (dished). heads have been ported quite a bit with stock valves. cam is an erson 4.88lift 292duration i think (been a few years since i built it) intake is a victor single plane with a holley 650dp. and...

in highschool abt 4 years ago i built a 360 for my duster. its a 77 block out of a van. its stock bore, stock dished pistons, stock heads ported with bigger springs (dont remember the spec) the cam is an erson 480 lift 292 duration. it has an edelbrock victor intake and a holley 650 double...

i just got a quick question. i got factory heads on my 77 360. 480 cam 292 duration, stock dished pistons, heads have been ported with new valves and alittle heavier springs. (i dont remember exact specs on heads for i built it along time ago in highschool at the speed shop). my question...

i have a 360 out of a 77 dodge van. its stock bore, flat tops. has an erson cam with around 480 lift 292 duration. i would like to get some aluminum heads for it. or even some higher comp iron heads for it. what do you guys recomend? i am on a budget, whats the best bang for the buck? thanks

i just got a 360 out of a 99 ram 2500 (freebie) it runs but has a slight knock. i was wondering if the heads on it are better than the heads on my 360 in my duster. my engine is a 77 360 out of a van with stick heads, ported, new valves and stiffer springs. i had heard that the newer heads...

i recently purchased an edelbrock victor sr intake. its for my 360. i have a 727 in the car. the question is: what modifications, if any, will be needed to make my throttle pressure linkage work properly? will it sit too low from the carb? will i have to extend the linkage? im also running a...

when i did my engine wap into my 72 duster, i installed a GM HEI distributor that was fitted for mopar. its just a simple summit brand dist. anyways. ive had it in the car for abt a year with no problems. but ive recently spotted an oil leak at the back of the engine. i resealed the oil...