Search results for query: *

:study:I just turned my rear wheel 10 times, while counting the driveshaft weight @ 16 times. I think I was supposed to count the drive shaft yokes, that would have given me 32 revolutions. which I think would be 3.23 gears. Do you guys agree or did I do it wrong? thanks Walt:coffee2:

I have a 8 3/4 center section with 4 cap bolts broke off the yoke. (the center is out). Do you guys think I should replace the yoke or try to get the broken bolts out? Can i change the yoke only or would the pinion have to be reset? I am on a small budget. Thanks for any input .. Walt:angry7:

Had this 904 rebuilt a couple years ago and never looked at it. When i pulled the plastic off of it the other day I see a hole near the shaft. Can someone tell me what goes in the hole? thanks Walt

Hi, Need help on identifying the pinion and ring gear on the left side of pic? The one on the right is an 8 1/4. The splines are different and the one on the left also has a smaller shaft thread. It has these markings on the pinion" 8X35 (asmall logo) 8C 1 17". Can anyone help? Is it a mopar...

Hi, Need help with identifying a ring and pinion? The one on the left was thought to be a 4.30 ratio 8 1/4 when I bought it on ebay but it is smaller than the 3.73 8 1/4 on the right!!! The ring gear or pinion has no markings or numbers on either. The ring gear measurers around 7.7/8ths. I...

Can anyone steer me to a tech article on setting up a ring and pinion in an 8 1/4 rear, I searched the tech tab and couldn't find any posts on this. Thanks walt :sad1:

:toothy7: Hi, Need some advice. I have heard from a friend that some v-8 monarchs and Granadas had 9" rears that are a perfect bolt in for a mopar A body. If this is true it would help us guys who can't afford an 8.75 mopar. Does anyone know if this is true or has anyone else heard this? thanks...

Hi, I recently tore down a 340 short block I just bought to rebuild for my duster, it had a 294/510 cam in it with solid lifters. I had already purchased a xe 268 H cam and a 1000 over tci converter for the 904. My question is can i run the bigger cam with the converter I have and can I run the...

? rear end ratio Hi, can anyone tell me what the ratio would be on an 8X35 tooth count? thanks walt

I picked up a rebuilt 904, shift kit, heavy clutches last weekend. The guy I bought it from said there was no oil in it. When I got home i stood it up on the bell housing in the garage, two days later there is a big oil stain on the floor. appears to be about a pint leaked out. I know nothing...

:cwm10: I am building a 340 for my duster, comp xe268 cam. My new tci converter says it is 1000 over stock stall. What kind of stall can i expect with this set up? What was the stock stall for a 340 attached to a built 904? Any help will be appreciated. Also I am not sure if the 340 short block...