Your next project??
Starting price is good.
But it will tie up ypour shop space for a while....
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Starting price is good.
But it will tie up ypour shop space for a while....
Threw a low bid at it last time it is a parts car full of one year gold at best!
i have a couple duraspark dizzys at home. I need to reinstall one with an hei as well.
Have to love the last pic of the bolt in the tire!
Hate them. Last one was my dads and when we were in town found out a old friend was having his also that weekend double suck!
Unconventional
Well-Known Member
It's Mopar Monday.
Good morning.
Café du Monde also
'Giantkiller' Mike on Racing Fuel Systems is a good resource there.
Also a couple of guys on their that restore carbs for Ford applications almost exclusively. I can't remember if its Deeproots or someone else. IIRC he has a primary job like yours.
Chicory, I don't think I have ever had chicory.View attachment 1715414940
It's Mopar Monday.
Good morning.
View attachment 1715414941
How do you know her name is Chick or he?
Last edited:
You get it a lot in Louisiana.
Looks easy.
Unconventional
Well-Known Member
Chock Full o' Nuts coffee has chickory if I remember right. Air Force Captain friend o' mine sent me Café du Monde after he found it in NO, hooked ever since. Makes "curl your hair" espresso 
Very just get the polarity from the pick up right.
Cool replacement light sockets for those pressed/peened in stock sockets. B/U light socket replacement
Actually easier with the spring on. Not my pic, mine slip in further and can't get to the washer hole.
Unconventional
Well-Known Member
LOL no thanks. They do serve a purpose. I have a rear signal on my Swinger that had a bad socket. MaMopar peened/flared them into the sockets so they aren't replaceable unless you somehow peel them out and replace them with one that plugs in. It looks like these screw in and would provide a good ground.Those would look good with some colorful LEDs in them
What is that potting material anyway. Liquid silicone when it's poured in?IIRC Nacho cut the potting material - maybe with a hot knife?? Don't remember and I think last I looked his photos had been deleted.
Unconventional
Well-Known Member
OMG .. Teenage flashback! '64 Impalas with 14x5 Cragars and lights in the fenderwells. I may hurl! Stand away from your monitors! 
Much better than last time. This winter is going to bring a Wieand Tunnel Ram and a pair of 660 Holleys....
Its simular to an epoxy.
Just curious, never tried to cut it out. Can it be softened with heat?
That is the set up I run on my Demon and Dad runs on his Barracuda. No more ballast resistors and parts can be picked up cheap anywhere should there be any issue.
Never another 66 Charger for me......
The jacking cards for the legs on one of the other boats were covered in the same material.
-
