Recent content by bobs340dartsport

anybody have any "driver" quality ones for use on a race/street car?? Bob

I hope those parts were waterproof! I just got back from there, I hope Saturday is a drier day!!

It has a Holley 1 barrel carb

I ahd computer issues and my current ID is registered to my work email, so I had to reregister to a new username! Yes I still have it and yes it will work with your manual trans (the crank hub diameter change happened around 1968 or so, which means a 1981 engine will work in a 1981 vehicle...

I mounted a Summit 8 gallon fuel cell in the spare tire well of my 73 dart sport. I fabricated a frame to mount the fuel cell to the floor of the spare tire well out of 1X1 steel angle. Only had to drill four small holes in bottom for 1/4" bolts (mount frame) and a 5/8" hole (fuel line). Bob

Great job on the dart sport! Now I know what I want to do with mine when I retire it from racing. Bob

great pics. I went to training class in April around the corner from there back in April. We went to museum and loved it. They have quite a car show going on inside that building also!! Bob

I used shopline 2K urethane primer on my dart sport when I painted it a few years ago. The primer worked fine and was quite affordable. I did not use shopline or PPG color on the car because the vendor who sold me the shopline primer would not provide me a data sheet on the shopline paints...

just build it stock, my 67 barracuda convertible (273 2 bbl/auto) got 21-22 mpg with over 100K miles on powertrain.

Competition Engineering on all four corners, with MP SS springs out back. they work great!! Bob

Where are you (and the parts car) located? Thanks, Bob

A friend of mine at the track is looking for a drivers door window glass for a 1968 Dart 2 door post car. Anyone out there have one? Thanks, Bob

if you have a SBP rear you can buy new reproduction mopar rallye wheels in sizes up to 15 X 8 to fit it. I got mine from summit for about $100 each shipped to me in MD. I found this to be the most cost effective way to mount slicks on back of my Dart Sport with a SBP 8 3/4" rear (which came...

These are still produced by aftermarket auto glass manufacturers . I bought an aftermarket WS and had it installed with a new reproduction WS gasket (from Year one) in my 1973 dart sport. At the time I inquired about being able to get a WS for my 1967 barracuda convertible , they checked and...

Factory SBP rallye wheels are 14 X 5.5, anything else had been modified or is a reproduction (like the 15 X 8 SBP's I have on the back of my car) Bob