Search results for query: *

Or a BFH... LOL...Or the Clamp Tool... LOL

You need a BFH !!!!!!!!

Yes... You can buy Individual/universal boots from your local auto parts store.

Lose Weight....:lol:

I believe he is asking about removing the shaft and arm from the K frame....

I run the nut out to the end of the threads,,and hit it with a BFH...

Also... Use RED Loctite Threadlocker on the Bolts when you re install it.

Air Hammer and Vise is all you need.

NO !!

Don at Cecil's Alignment Center. Edgewater Md. 231037 410-798-0181. This guy is 65, been around forever, and can align anything properly. Even heats straight axles on Big trucks for alignment.

No I don't think so Jeff. They squeeze together tight when installed. I have always had to pound them into place with a rubber mallet, using the outer caps.

I just put Delrin bushings in a guys Road Race 2nd Gen Pontiac F body. He raced it , the next day and thought they were the Shizzit. No personal experience though.

I have a set here now, to install on a customers 79 Trans Am. I'll let you all know how it goes. Im installing a lot of stuff on his car for road racing. Coil over front suspension, C5 Corvette front brakes with Yellow Stuff pads, rear yellow Stuff pads, Solid body mounts, Etc. Here's a pic of...

Had to do some repair patches on mine as well. Well known problem.

I like to use Moog Parts. Mostly available from your Professional Auto Parts Store.

Used to sell them all the time in MOOG, back in the day.

Nope !! These cars weren't built perfect. Do what you need to suit your purpose.

Motormite/Help/Dorman from your Parts Store.

Mine looked like bare metal or grey. So I blasted mine to bare metal. Primed it and painted it with Spray Grey.Looks Great. See my build thread.

Sure, That way you can pull the K member and clean and paint it.

I'm sure you are talking about the LCA pin. One on each side presses into the LCA bushing and then the arm. Other end attaches to K frame. They are available aftermarket.

Numbers Car !!

Not Applicable here.

Good question. I've actually been corrected on Either. LOL

68 Dart Front 55-RO82 Rear 55-RO92 Bilstien

Guess I'll find out. I bought a set for the GTS project. Soon to be assembled and under it's own power.

What happens some times with these bolts is that they loosen up over time. And probably without your knowledge , the steering got slightly looser. Meanwhile the bolts waller around in the threads and wear them out. It is good practice to check them regularly. When I restore a car, I always use...

Some of the Moog ball joints have a metal ring inside the boot where it meets the joint. It is supposed to fit tight. Also notice that there is a slot, usually for excess grease to escape. Should go to the inside of the car. I use a short piece of the right diameter exhaust pipe with a block of...

What is that ??

Try some of the Lucas Steering Fix product. I have used it many times on customers cars with small leaks or noise.